Blew a tube sheet on a small boiler last Thursday and I'm second guessing how I prepped the bevel
Was rolling in a replacement tube on an old Cleaver-Brooks unit at a laundry plant in Dayton last Thursday and the weld pulled a pinhole right at the tube sheet face on the first pass. I ground it back out, cleaned the bevel again with a fresh burr, and re-ran it hotter and slower with a tighter weave, and it held on the hydro. Now I'm wondering if my prep was too light the first time or if the tube sheet was just oil soaked from years of washdown. Curious what you all do for prep on a dirty firetube, and has anyone had the tube sheet metal fight them like this?