PSA: switched from a hot glue gun to plain CA glue on my 3D prints and the seam gaps vanished
Been putting together a little fleet of printed planter boxes for my windowsill the last two weeks. First four got glued with hot glue and every single seam had a visible gap you could slide a fingernail into. Last night I tried plain CA glue with a light accelerator instead, and the parts sat flush on the first try, no clamping, no waiting around at 2am. The thin stuff wicks right into the joint and sets in about 10 seconds, which honestly saved me from a bunch of rubber band jigs I hated. I'm no expert at this stuff and always figured hot glue was good enough for hobby prints. Anyone else ditch the glue gun for assembly, or do you just design snap fits and skip adhesive altogether?