My kitchen spatula just fixed my screen tension problem

I kept getting these wavy lines on my prints, especially on bigger designs, and I figured it was my cheap hinge clamps letting the screen shift. After 3 ruined shirts last Saturday, I grabbed this old rubber spatula from the drawer and used the flat edge to press the screen down hard against the platen while I pulled the squeegee. The flex in the rubber actually held the mesh tighter in the center, no more ghosting on the edges. It's not a real tension meter or anything, but it worked better than my loose tape trick. Anyone else ever use weird kitchen stuff for a quick fix on a stubborn print?

1 comments

1 Comment

jade2262d ago

You ever have one of those moments where you realize your "professional" setup is just fancy tape and hope? Because I'm pretty sure my best print tool is a butter knife I stole from the kitchen drawer.